In the process of excavator operation, the use of pure parts can not only reduce the operating cost of the whole machine, but also prolong the service life, and ultimately protect the vital interests ...
Bucket teeth of excavators are important wearable parts on excavators. They are similar to human teeth. They are composed of a combined bucket teeth, which are connected by pin shafts. Since the wear ...
Loader bucket belongs to structural parts products. It consists of toothed base plate, bottom plate, side plate, wallboard, hanging ear plate, back plate, bucket ear plate, bucket ear cover, bucket te...
Bucket teeth are the most vulnerable to damage in the use of the whole set of equipment. Choosing the right type can achieve twice the result with half the effort in the project and avoid unnecessary ...
Usually when making bucket teeth castings, the steel consumes higher temperature and the pouring temperature is too high, which also leads to greater erosion of the casting mould, and the formation of...
I. Cast-in Bucket TeethHigh toughness high manganese steel is generally used as base material in inlaying bucket teeth, and high chromium cast iron is used as inlay block. When it is used to dig f=16-...
Hot cracks occur in bucket teeth during solidification, when bucket teeth are in plastic deformation state. The liquid metal solidifies from the surface of the castings under the heat transfer of the ...
In order to improve the wear resistance of bucket teeth, it is necessary to select reasonable welding materials during surfacing. The selection principle of surfacing welding material for high mangane...
I. Notes(1) Steel plate should not be too wide, usually 50 mm.(2) The steel plate must be welded at the front of the bucket teeth so that the undisturbed soil is not easily disturbed.(3) The steel pla...
Bucket teeth are moulded with resin sand, shovel heads are made of riseless casting technology, shovel bases are made of appetite and chilled iron. Since the shovel heads and shovel bases of bucket te...
The bucket teeth of an open-pit excavator fail early due to severe wear and tear. In view of these bucket teeth, the failure forms and causes of bucket teeth surface of the excavator are analyzed, and...
According to the forming principle of squeeze casting, the forming of bucket teeth is a process of metal liquid flowing from chamber to cavity under pressure. The dynamic force of the flow is the pres...
When the bucket teeth of excavator work, they first contact the mineral at a certain speed, which produces impact force; then the ore slides on the tooth surface under its own gravity and causes wear ...
Through a lot of practice, it has been proved that there are many factors affecting the service life of bucket teeth. Besides the ore structure, the degree of hardness and softness, the blasting situa...
With people's continuous updating and innovation of various products, new products continue to enter the market, a variety of products dazzling, at this time, how can we distinguish between good a...
With the increasing use of excavators, more and more projects are gradually adapted to the existence of such equipment. But with the use of excavators, the loss of bucket teeth of excavators is also i...
